Wellcraft Cruisers Manuel du propriétaire télécharger pdf (Page 103)

• Inspect all exhaust connections for carbon

monoxide leakage. Adjust and repair as

required.

• Test the navigational lights and all other

lighting on board.

• Inspect all wiring for fraying, wear, loose

connections and other damage.

• Inspect all switches, controls and other

related equipment for proper operation.

• Inspect all safety equipment for proper oper-

ation and physical condition.

• Open all faucets and fill freshwater holding

tank with water. Turn freshwater pump on to

allow water to flow through faucets until all

antifreeze is flushed out and the water runs

clear, then close faucets. Fill the freshwater

tank until full, then check the entire system

for water leaks.

• Launch the boat and start the engine. It

may take a minute of cranking to allow the

fuel system to prime. When the engine

starts, keep a close watch over the gauge

readings and check for leakage and abnor-

mal noises. Keep speeds low until the

engine has reached normal operating tem-

perature. If your engine was fogged for

winterization, you will see exhaust smoke

for a few minutes while the fogging oil is

burned off.

Refer to engine and boat accessory manuals for

further recommissioning instructions.

11-6

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 118 119

Pas de commentaire

Wellcraft Cruisers Manuel du propriétaire Page 103